Serving Bowie, Maryland & Surrounding Areas(240) 338-0049
    Pentagon Air heating and air conditioning logo
    Flame sensor cleaning in Bowie MD

    Flame Sensor Cleaning in Bowie, MD | Quick Fix, Big Difference

    Furnace starts then shuts off after a few seconds? A dirty flame sensor is the most likely cause.

    Fully Insured 24/7 Service Free Estimates No Trip Charge

    This is the repair that saves Bowie homeowners the most money. because another company might tell you that you need a new furnace when all you actually need is a 30-minute sensor cleaning. Your furnace lights up, runs for a few seconds, then shuts off. It tries again. Same thing. After three or four attempts, it locks out and you're cold. The flame sensor is coated with carbon buildup and can't detect the flame, so the safety system shuts off the gas. Pentagon Air cleans flame sensors across Bowie quickly and affordably.

    When You Need Flame Sensor Cleaning

    The classic symptom: furnace ignites, runs for 3 to 10 seconds, then shuts off. It repeats this cycle until it locks out. The flame sensor is a small metal rod that sits in the burner flame and tells the control board that the gas is actually burning. When carbon builds up on the rod. which happens naturally over time. it can't sense the flame and triggers a safety shutdown. This is a quick fix that doesn't require replacing any parts.

    Our Flame Sensor Cleaning Process

    We remove the flame sensor from the burner assembly, clean it with fine abrasive to remove the carbon buildup, reinstall it, and test the furnace through several heating cycles. We verify the sensor is reading properly and the furnace stays lit reliably. The entire process takes about 30 minutes. If the sensor is cracked or corroded beyond cleaning, we replace it. but that's rare.

    Flame Sensor Cleaning Cost in Bowie

    This is one of the least expensive furnace repairs we do. We quote upfront. no hidden fees. If another company told you that you need a new furnace or a $500 repair for this symptom, call us for a second opinion. There's a good chance it's a $100 flame sensor cleaning.

    Why Choose Us

    Pentagon Air handles flame sensor cleaning quickly, honestly, and affordably. We won't tell you that your 8-year-old furnace needs to be replaced when all it needs is a simple cleaning. That's not how we do business. Honest service, licensed technicians. We've cleaned hundreds of flame sensors in Bowie homes.

    Back to Furnace Repair Service

    Furnace starting and stopping? Call Pentagon Air at (240) 338-0049. It's probably a flame sensor. quick and affordable to fix.